Page 4 of 5
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:33 pm
by steve578
Flange off and staring straight at the devil.
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:37 pm
by steve578
Bearing removed and looking straight into the IMS tube.
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:38 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:40 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:42 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:43 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:44 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:49 pm
by steve578
Today was the RMS. I placed a screw into the existing RMS and then used a pry bar to remove it. It was pretty easy. The mounting surfaces were cleaned with acetone and a lint free cloth. I bought a 3D printed RMS install tool from ChrisMA from Rennlist (dammit). Place the new seal on the crankshaft and then tighten down.
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:49 pm
by steve578
Re: DIY IMS Solution Install
Posted: Mon Feb 19, 2018 1:51 pm
by steve578