DIY Joe Toth 996 Turbo Inlets

Moderator: FRUNKenstein

Post Reply
User avatar
TheDeckMan
OG (First 100 Outposters!)
Posts: 259
Joined: Fri Feb 16, 2018 8:52 am
Location: Masshole behind communist lines
Contact:

DIY Joe Toth 996 Turbo Inlets

Post by TheDeckMan » Thu Mar 15, 2018 6:34 am

Installing the Joe Toth inlets is fairly straight forward after applying 3M High Strength Double sided tape to them.

I used painters tape to hold in position applying pressure to the inlets for a weekend prior to driving. Make sure to remove all wax off the old inlets prior to sticking the tap to ensure good adhesion.
Image
996TT - GT2 Clone Build -RWD, UMW Tune, H&R RSS, Phenix Engineering Control Arms/LCA's, GT3 6 Pistons, SpeedTech 3" X-Pipe, Ported Headers, 997 GT3 Shifter, GT3 Buckets, GT2 Clutch/PP, GT2RS IC's, RSS Roll Bar, GT3 Brake Ducts, Joe Toth Aero/Ducts
997TT - Sport Chrono, LSD, UMW Tune, DSC, Phenix Engineering Toe Links & LCA Bushings, Tubi Race
Audi TT Track Car
Corrado SLC
Corrado SLC
MG Midget

Post Reply