Re: 02 Roller Landed in My Lap!
Posted: Sun Jul 29, 2018 7:10 am
I have more, would you like to see them?
996Outpost.com
THE community for Porsche 996 enthusiasts!
https://996outpost.com/
02 Roller Landed in My Lap!
Page 12 of 15
Re: 02 Roller Landed in My Lap!
Posted: Sun Jul 29, 2018 12:33 pm
Re: 02 Roller Landed in My Lap!
Posted: Sun Jul 29, 2018 5:11 pm
Replaced my lower rear Tract Rods (aka Toe Control) and discovered a cracked bushing. Unseen unless you remove them.
I wonder how many others are driving around like this?
I wonder how many others are driving around like this?
Re: 02 Roller Landed in My Lap!
Posted: Fri Aug 03, 2018 7:43 am
Motor is on island and ready for pick up! Now if only Hurricane Hector would go away...
Re: 02 Roller Landed in My Lap!
Posted: Fri Aug 03, 2018 8:30 am
Re: 02 Roller Landed in My Lap!
Posted: Fri Aug 03, 2018 9:05 am
Just like Iwa and Iniki, then they made a hard right to Kauai...Direct hit!
Re: 02 Roller Landed in My Lap!
Posted: Fri Aug 03, 2018 3:33 pm
It was always fun parting out 356's when they were rusted beyond repair. Of course those parts are worth more than jewelry and there was great fun and profit. Those were the days.....(Edith and Archie singing in background)
Would be fun to part out a 996 - Just taking your time, organizing them and do some ebay/forum sales - I'd guestimate close to $12K in parts sales - Hell the engine alone should fetch $2-3K for all the usable parts?
Lots of work but fun stuff
Would be fun to part out a 996 - Just taking your time, organizing them and do some ebay/forum sales - I'd guestimate close to $12K in parts sales - Hell the engine alone should fetch $2-3K for all the usable parts?
Lots of work but fun stuff
Re: 02 Roller Landed in My Lap!
Posted: Sun Aug 05, 2018 2:47 pm
Picked up the motor and pulled the flywheel to see this...I had already planned on replacing the IMSB and RMS.
My question is how does one determine if it's a non servicable bearing? Motor is an AT built in 05. 22mm nut.
My question is how does one determine if it's a non servicable bearing? Motor is an AT built in 05. 22mm nut.
Re: 02 Roller Landed in My Lap!
Posted: Sun Aug 05, 2018 3:25 pm
Big nut = big pain in the ass
You gotta crack the case to do it right. There is an option out there to drill it out, but that just seems like a horrible idea to me (you going to bet that motor against being damn sure no debris gets left in the oil area?).
You gotta crack the case to do it right. There is an option out there to drill it out, but that just seems like a horrible idea to me (you going to bet that motor against being damn sure no debris gets left in the oil area?).
Re: 02 Roller Landed in My Lap!
Posted: Sun Aug 05, 2018 4:16 pm
That's what I thought, I'll just have to pull the flange and pop off the oil seal and have a look. I sure hope the RMS is the source of oil and not the IMSB flange.
Who's got the cam locking tools to loan/rent?
Who's got the cam locking tools to loan/rent?