Page 34 of 207

Re: What did you do to/with your 996 today?

Posted: Fri Aug 17, 2018 9:58 am
by B3DAWG
Wow... the pokey dot look is really ... ummm... cool... ya.. cool I say... just need some rainbows and unicorn and it would be perrrrfect! :D

Re: What did you do to/with your 996 today?

Posted: Fri Aug 17, 2018 10:35 am
by FRUNKenstein
b3freak wrote: Fri Aug 17, 2018 9:58 am Wow... the pokey dot look is really ... ummm... cool... ya.. cool I say... just need some rainbows and unicorn semen and it would be perrrrfect! :D
FIFY

Re: What did you do to/with your 996 today?

Posted: Sat Aug 18, 2018 11:58 am
by sweet victory
I ordered the unicorn semen aka Porsche Coolant. I purchased the "rainbows and sunshine" variety of rainbows. Will I have a negative experience if it's not the original "Rainbow" variety? M96 experts tell me I MUST use the sunshine additive or I may as well start counting my days till the engine goes.

Re: What did you do to/with your 996 today?

Posted: Sat Aug 18, 2018 4:03 pm
by Astro
I loosened the bolts and clamps that hold the muffler to the main output piping. Amazingly enough, i didn't strip them or break them off(I don't think they've ever been loosened since factory installation). I've been reading up on maybe doing a muffler delete, but don't really feel like spending any money until I know if I'll like it, so i thought i would see if I could create a gap, I would get a feel for what it sounds like. Unfortunately, I was unable to create a gap without actually removing the muffler, so I put the bolts back on. Exciting stuff, I know...

Re: What did you do to/with your 996 today?

Posted: Sun Aug 19, 2018 12:25 pm
by 808Bill
Built an engine stand...

Re: What did you do to/with your 996 today?

Posted: Sun Aug 19, 2018 3:52 pm
by Dr_Strangelove
Nice, Bill! What steps are left before new lump goes in the car?


(I'm taking my engine out right now. My car is a rusty sonuva gun...)

Re: What did you do to/with your 996 today?

Posted: Sun Aug 19, 2018 5:06 pm
by 32wildbilly
Dr_Strangelove (whew!) wrote: Sun Aug 19, 2018 3:52 pm Nice, Bill! What steps are left before new lump goes in the car?


(I'm taking my engine out right now. My car is a rusty sonuva gun...)
You mean out of your "new" cab right? Not out of the "old" car...right?

Re: What did you do to/with your 996 today?

Posted: Sun Aug 19, 2018 10:18 pm
by 808Bill
Dr_Strangelove (whew!) wrote: Sun Aug 19, 2018 3:52 pm Nice, Bill! What steps are left before new lump goes in the car?


(I'm taking my engine out right now. My car is a rusty sonuva gun...)
Pop off the IMSB grease seal, rms, clutch and then the fuel rails, wire harness, intake and runners put back on.
I really hope to be mounting the motor next Monday.

Re: What did you do to/with your 996 today?

Posted: Mon Aug 20, 2018 10:19 am
by Dr_Strangelove
32wildbilly wrote: Sun Aug 19, 2018 5:06 pm You mean out of your "new" cab right? Not out of the "old" car...right?
You are correct, sir ;)

Re: What did you do to/with your 996 today?

Posted: Mon Aug 20, 2018 1:01 pm
by 32wildbilly
Dr_Strangelove (whew!) wrote: Mon Aug 20, 2018 10:19 am
32wildbilly wrote: Sun Aug 19, 2018 5:06 pm You mean out of your "new" cab right? Not out of the "old" car...right?
You are correct, sir ;)
Whew! I thought I missed something.